Limited stocks for this item.
This mold has 2 parts to make a 3D nursing milk bottle. It makes milk bottles of 1 size.
Compatible with UV resin, polymer clay, resin clay, silver clay, soap, air dry clay (eg: Hearty and Angel clay).
Measurement:
3.3cm height, 1.55cm wide (Approximate)
You will need to trim off the excess at the sides using a pair of clippers (not included in purchase)
Origin: Japan
Material: Silicone Rubber
Recommended to apply a thin layer of baby oil or mold oil so that your clay pops out easily.
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
This mold has 2 parts to make a 3D nursing milk bottle. It makes milk bottles of 1 size.
Compatible with UV resin, polymer clay, resin clay, silver clay, soap, air dry clay (eg: Hearty and Angel clay).
Measurement:
3.3cm height, 1.55cm wide (Approximate)
You will need to trim off the excess at the sides using a pair of clippers (not included in purchase)
Origin: Japan
Material: Silicone Rubber
Recommended to apply a thin layer of baby oil or mold oil so that your clay pops out easily.
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix