This mold makes a 3D heart piece using 2 parts that fit together snugly. It's for use with UV resin and can be used with UV resin films and stickers / glitter.
This heart mold is available in 2 sizes (Small or Big type). Measurements below.
Please select size of the mold in the drop down menu.
Measurement (approximate):
SMALL type
1.7 cm height x 2 cm wide
(0.67 x 0.78 inches)
BIG type
2.5 cm height x 3.2 cm wide
(0.98 x 1.26 inches)
Please allow for small difference in size of final product as UV resin and clay will shrink slightly after curing / baking.
Please use mold release agent when using epoxy and avoid leaving resin for extended periods of time inside the mold.
Made in Japan
Material: Silicone
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
This heart mold is available in 2 sizes (Small or Big type). Measurements below.
Please select size of the mold in the drop down menu.
Measurement (approximate):
SMALL type
1.7 cm height x 2 cm wide
(0.67 x 0.78 inches)
BIG type
2.5 cm height x 3.2 cm wide
(0.98 x 1.26 inches)
Please allow for small difference in size of final product as UV resin and clay will shrink slightly after curing / baking.
Please use mold release agent when using epoxy and avoid leaving resin for extended periods of time inside the mold.
Made in Japan
Material: Silicone
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix