Also known as "炎" (Homura), this 2-part mold makes a burning flame charm that can be used as a charm itself, or combine with other structures to make mini fake torch / earrings and other accessories.
Ruler of main image is in cm, not inches.
Measurement of completed flame (approximate):
20mm×12mm×10mm
(0.79" x 0.47" x 0.39")
Make cute little 3D flame charms with this 2-part mold!
Compatible with UV resin, polymer clay, AB resin
There could be shrinkage of clay and resin after completion.
This mold is handmade and may require some time to be ready.
Made in Japan
Material: Silicone
Recommended to apply a thin layer of baby oil or mold oil so that your clay pops out easily.
Please take the clay out of the mold before baking the clay in oven.
We advise against putting the mold inside high heat oven as silicone naturally degrades under extreme heat.
Tips for maintaining life of reusable silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
Ruler of main image is in cm, not inches.
Measurement of completed flame (approximate):
20mm×12mm×10mm
(0.79" x 0.47" x 0.39")
Make cute little 3D flame charms with this 2-part mold!
Compatible with UV resin, polymer clay, AB resin
There could be shrinkage of clay and resin after completion.
This mold is handmade and may require some time to be ready.
Made in Japan
Material: Silicone
Recommended to apply a thin layer of baby oil or mold oil so that your clay pops out easily.
Please take the clay out of the mold before baking the clay in oven.
We advise against putting the mold inside high heat oven as silicone naturally degrades under extreme heat.
Tips for maintaining life of reusable silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix