- This mold makes a 3D bowling pin piece using 2 parts.
- This mold is available in 2 sizes (Small or Big type). Measurements below.
- Please select size of the mold in the drop down menu.
Measurements:
SMALL pin
3.5 cm x 1.3 cm wide (1.37 x 0.51 inches)
BIG pin
2.5 cm tall x 0.9 cm wide (0.98 x 0.35 inches)
- It's for use with UV resin and can be used with UV resin films and stickers / glitter.
- Please allow for small difference in size of final product as UV resin and clay will shrink between 10% to 30% after curing / baking.
- Please use mold release agent and avoid leaving the resin in the mold for extended periods of time to maintain the silicone condition.
Made in Japan
Material: Silicone
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
- This mold is available in 2 sizes (Small or Big type). Measurements below.
- Please select size of the mold in the drop down menu.
Measurements:
SMALL pin
3.5 cm x 1.3 cm wide (1.37 x 0.51 inches)
BIG pin
2.5 cm tall x 0.9 cm wide (0.98 x 0.35 inches)
- It's for use with UV resin and can be used with UV resin films and stickers / glitter.
- Please allow for small difference in size of final product as UV resin and clay will shrink between 10% to 30% after curing / baking.
- Please use mold release agent and avoid leaving the resin in the mold for extended periods of time to maintain the silicone condition.
Made in Japan
Material: Silicone
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix