Make miniature bat wings as charms or miniature ornaments for dollhouses!
It's a great halloween addition to your craft collection.
Size of wings
Height: 1cm (0.39 inches)
Width: 1.5cm (0.59 inches)
Made in Japan
Material: Silicone
Suitable for use with:
UV resin, epoxy, polymer clay, silver clay, gold clay, air dry clay
- Please allow for small difference in size of final product as UV resin and clay will shrink between 10% to 30% after curing / baking.
- Use mold release agent and avoid leaving the resin in the mold for extended periods of time to maintain the silicone condition.
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
It's a great halloween addition to your craft collection.
Size of wings
Height: 1cm (0.39 inches)
Width: 1.5cm (0.59 inches)
Made in Japan
Material: Silicone
Suitable for use with:
UV resin, epoxy, polymer clay, silver clay, gold clay, air dry clay
- Please allow for small difference in size of final product as UV resin and clay will shrink between 10% to 30% after curing / baking.
- Use mold release agent and avoid leaving the resin in the mold for extended periods of time to maintain the silicone condition.
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix