This is a mold set consisting of:
1x 3D Lip Gloss Mold
1x 3D Eyeshadow Palette Mold
Final size after completion:
Eyeshadow palette approx. 25 x 32 x 4.5mm (0.98" x 1.25" x 0.177")
Lip gloss Approximately 50 x 20 x 9.5 mm (1.96" x 0.79" x 0.37")
For use with UV resin and can be used with UV resin films and stickers / glitter.
Please allow for small difference in size of final product as UV resin and clay will shrink between 10% to 30% after curing / baking.
From Japan
Material: Silicone
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
- *The silicone mold is a consumable item. It will deteriorate with each use. The amount of wear and tear seems to vary depending on how you use it.
1x 3D Lip Gloss Mold
1x 3D Eyeshadow Palette Mold
Final size after completion:
Eyeshadow palette approx. 25 x 32 x 4.5mm (0.98" x 1.25" x 0.177")
Lip gloss Approximately 50 x 20 x 9.5 mm (1.96" x 0.79" x 0.37")
For use with UV resin and can be used with UV resin films and stickers / glitter.
Please allow for small difference in size of final product as UV resin and clay will shrink between 10% to 30% after curing / baking.
From Japan
Material: Silicone
Tips for maintaining life of silicone molds:
- Demold as soon as the resin is cured to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix
- *The silicone mold is a consumable item. It will deteriorate with each use. The amount of wear and tear seems to vary depending on how you use it.